The 2009 Nissan Murano windshield washer reservoir is a crucial component for maintaining visibility while driving. This guide provides essential information for Murano owners regarding the reservoir's location, maintenance, and troubleshooting common issues.

Understanding the Windshield Washer Reservoir

The windshield washer reservoir in the 2009 Nissan Murano holds the washer fluid that cleans the windshield. It is vital for ensuring clear visibility during adverse weather conditions. Over time, issues may arise with this component, such as leaks or pump failures.

Location of the Reservoir

The windshield washer reservoir is typically located near the front of the vehicle, often on the driver's side. To access it:

  • Open the hood of your Murano.
  • Look for a large plastic container with a cap labeled for windshield washer fluid.

Adding Washer Fluid

Adding washer fluid is a straightforward process:

  • Remove the cap from the reservoir.
  • Pour in the appropriate windshield washer fluid until it reaches the fill line.
  • Replace the cap securely.

Important Note: You cannot overfill this reservoir, so feel free to fill it until it reaches capacity.

Common Issues and Solutions

Washer Fluid Not Spraying

If your windshield washer fluid is not spraying, consider these potential causes:

  • Empty Reservoir: Check if there is enough fluid in the reservoir.
  • Clogged Nozzles: Inspect and clean the nozzles if they are blocked.
  • Faulty Pump: If you hear no sound when activating the washer, the pump may need replacement.

Replacing the Washer Pump

If you determine that the pump is malfunctioning, follow these steps to replace it:

1. Remove Wheel Well Liner: Loosen lug nuts and jack up the vehicle. Remove plastic clips from the wheel well to access the pump.

2. Disconnect Power Connector: Press down on the tap to unlock and disconnect it from the tank.

3. Remove Old Pump: Wiggle and pull out the pump from its grommet.

4. Install New Pump: Insert the new pump into place, ensuring it is secure.

5. Reconnect Everything: Reattach hoses and power connectors before replacing any covers or liners.

Checking for Leaks

After any repairs or replacements, always check for leaks:

  • Fill the reservoir and observe if any fluid escapes from cracks or loose connections.

FAQs About 2009 Nissan Murano Windshield Washer Reservoir

    • How do I know if my washer pump is bad?
      If you hear no sound when activating it or if fluid does not spray despite having fluid in the reservoir, it may be faulty.
    • Can I use plain water instead of washer fluid?
      While plain water can be used temporarily, it is not recommended as it may freeze in cold weather or not clean effectively.
    • How often should I check my washer fluid?
      It’s good practice to check your washer fluid level regularly, especially before long trips or during seasonal changes.

Maintaining your 2009 Nissan Murano's windshield washer reservoir ensures optimal performance and safety on the road. Regular checks and timely repairs can prevent visibility issues while driving.