Replacing the windshield washer reservoir in a Hyundai Veloster is a straightforward process that can be accomplished with some basic tools and a little patience. This guide will provide you with the necessary steps to successfully replace your vehicle's windshield washer reservoir.

Overview of the Windshield Washer Reservoir

The windshield washer reservoir is a critical component of your vehicle's washing system, designed to hold the washer fluid used to clean the windshield. Over time, these reservoirs can crack or leak, leading to inadequate fluid supply for windshield cleaning. If you notice that your washer fluid is consistently low or leaking, it may be time for a replacement.

Tools and Materials Needed

Before starting the replacement process, gather the following tools and materials:

  • 10mm socket and ratchet
  • Phillips screwdriver
  • Flat blade screwdriver
  • Trim tool set
  • Gloves
  • Safety glasses
  • New windshield washer reservoir (specific to Hyundai Veloster model)

Step-by-Step Replacement Process

1. Preparation

Ensure your vehicle is parked on a level surface and the engine is turned off. Open the hood and locate the windshield washer reservoir.

2. Remove the Front Bumper

- To access the reservoir, you will need to remove the front bumper. This typically involves unscrewing several clips and bolts.

- Use a 10mm socket to remove any bolts securing the bumper to the fender and underneath the vehicle.

3. Access Wheel Well

- Turn the front passenger wheel outward for better access.

- Remove any clips or screws from the wheel well lining that may obstruct access to the washer reservoir.

4. Disconnect Electrical Connections

- Locate the electrical connector for the washer pump at the bottom of the reservoir. Disconnect it by pressing down on the tab and pulling it off gently.

5. Remove Old Reservoir

- There are usually several bolts securing the reservoir in place; remove these with a 10mm socket.

- After all fasteners are removed, carefully pull out the reservoir from its position. Be cautious of any remaining fluid inside.

6. Install New Reservoir

- Position the new washer reservoir into place, ensuring it aligns with any mounting points.

- Reinstall all bolts that secure it to its bracket using a 10mm socket.

7. Reconnect Electrical Connections

- Reattach the electrical connector for the pump, ensuring it clicks into place securely.

8. Reassemble Front Bumper

- Carefully reattach the front bumper by aligning it with its mounting points and securing it with clips and bolts removed earlier.

9. Test Functionality

- Fill the new reservoir with washer fluid.

- Turn on your vehicle and test the functionality of the washer pump by activating it from inside.

Important Considerations

  • Always wear gloves and safety glasses while working on your vehicle to protect yourself from any sharp edges or fluids.
  • Make sure to dispose of any old washer fluid properly as it can be harmful to pets and wildlife.
  • If you encounter any issues during installation, consult your vehicle's service manual or seek professional assistance.

FAQs About Hyundai Veloster Windshield Washer Reservoir Replacement

    • How long does it take to replace?
      Typically, replacing the windshield washer reservoir takes about 1-2 hours.
    • What if my pump is also damaged?
      If your pump is leaking or not functioning properly, consider replacing it simultaneously with the reservoir.
    • Where can I purchase a new reservoir?
      You can find genuine Hyundai parts at dealerships or online auto parts retailers.